Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
grease fitting stuck
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="foton" data-source="post: 134945" data-attributes="member: 16041"><p>on my backhoe I had a stuck pin and I ended up welding a 1-1/4 round by 2 inch long block on the end of the pin so it would swell instad of the pin and make it even harder to remove when beating it out. It also give me more material to beat on so I was able to beat it longer to get it threw the pin brackets. Make sure that you check the pin for being straight ,I ended up putting it in a lathe and taking a few thousanths to take out a slight bend. made installation much easier.</p></blockquote><p></p>
[QUOTE="foton, post: 134945, member: 16041"] on my backhoe I had a stuck pin and I ended up welding a 1-1/4 round by 2 inch long block on the end of the pin so it would swell instad of the pin and make it even harder to remove when beating it out. It also give me more material to beat on so I was able to beat it longer to get it threw the pin brackets. Make sure that you check the pin for being straight ,I ended up putting it in a lathe and taking a few thousanths to take out a slight bend. made installation much easier. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
grease fitting stuck
Top