Recent content by joesmith123

solved I installed a new BICS solenoid to replace to swollen one pictured previously prayed before turning machine on that it would solve it, turned machine on, problem was solved

Yes I am hopeful that I will figure it out Before cleaning it and tracing the wires, I felt overwhelmed and doubtful, but Once I cleaned everything and tried to understand it, it feels more hopeful that I will fix it That solenoid barely had wires connected, and it looked swollen to the point...

Same, I must've spent 10 hours yesterday, testing voltages, reading through tons of old threads from all kinds of forums, watched tons of videos on how people deal with this From what I remember, when I put 12 volt into that circuit that the bad solenoid is on, I do remember the computer...

I was wondering how people were getting codes but all I know is to get to the screen that says "hydraulic lock valve open circuit" I will try, "pressing and holding the lights button" I thought the same, that the machine has had electrical problems but, Once I read up on the fuse panel, that...

I have been reading and going through what others have done, look at what I found, it could have been the problem This is the solenoid that controls the BICS for lift and tilt It looks cracked in half, and the wires under it were barely connected It could be the solution, tomorrow part...

error code fuse box, that wire was there when I opened it There is one flash on the lift tilt light

I am under the driver seat doing electrical diagnosis Voltage going to BICS solenoid, 4 volts There is ONE FLASH on the dash for the lift tilt fault Please help, machine is stuck and needs to be picked up I put 12 volt power to it like the video showed, except without relay, didnt work, it...